Conch Hotend® For Flashforge Adventurer 5M/5M Pro

o never knew i could easely overclock ,my printer to 200+% there are no better options, without this my flashforge adventurer 5m woudn't be this good, i wish they could make the flashforge creator 5/pro nozzle

Solid print head, it swapped out in minutes cut free and snaped back in place in seconds. If you want a .6mm print head; boom you got it. Got to temp quickly, fit like factory and hasn't clogged yet.

Works well be sure to tighten the nozzle before using

I was a little skeptical at first but to be fair that's how I am about anything I am shopping for. Fortunately this is something I am very glad I went ahead and purchased because it works GREAT! It heats up so much faster than the stock hotend and nozzle and even cools down faster too. It prints like a dream and the improved temperature control means I can print more filaments at speeds closer to this printers top speeds. I have seen more negative reviews than my personal experience says there should be which leads me to think they either received defective parts or they neglected the proper setup steps and didn't heat tighten the nozzle tip like it says you're supposed to in the instructions. Either way I have nothing but good things to say about this hotend nozzle combo and will most likely be purchasing another one when I need a replacement. Oh also I should note that another thing that makes this combo so awesome is that flashforge doesn't make a .4 hardened steel nozzle so if you want to print anything abrasive in a .4 size you're SOL but that is where this comes in and is actually why I purchased it but it's going to be my .4 workhorse from here on.

Excellent hotend, heats up super quick, prints better than stock