aeSupport™ S-PAHT

aeSupport™ S-PAHT Quick-Remove Support Material can achieve fast and easy peeling by adjusting the bonding strength to the support surface of the body material and the bonding strength of S-Multi itself. S-PAHT Quick-Remove Support Material does not require the use of water or solvents during the removal of the support and does not produce water pollution, which is safe and environmentally friendly. It can be used in dual printhead FDM printers or 2-in/1-out FDM printers.

Color: Beige

Diameter: 1.75mm / 2.85mm

Net weight: 500g / 1kg / 2.5kg

Recommended Nozzle:

DLC Hardened Steel Nozzle

Hardened Steel Nozzle

Ruby Nozzle

Recommended Hotend:Dragon series / Dragonfly series

Material Properties

PropertyTesting MethodTypical Value
DensityISO 11831.26 g/cm³
Water absorption

ISO 62:

Method 1

0.4%
Melting TemperatureISO 11357218℃
Melt index270℃, 2.16kg11

Recommended printing conditions

Nozzle Temperature270-280℃
Recommended Nozzle Diameter0.4-1.0mm
Recommended build surface treatmentCoating with PVP glue
Build plate temperature60-80℃
Raft separation distance0 mm
Recommended Support Infill Ratio15%-20%
Recommended Dense Support Layers3-5
Vertical Offset Top/Down Layers0
Horizontal offset0.3-0.6 mm
Support infill outlines0-1
Cooling fan speedOFF
Print speed30-120 mm/s
Retraction distance1-3 mm
Retraction speed1800-3600 mm/min

Suitable materials
aeForce™ PAHT
aeForce™ PAHT-CF
aeForce™ PAHT-GF

Additional Suggestions:

aesupport™ S-PAHT very easy to absorb moisture within the environment, and printing after absorbing moisture will result ozzing, extruding with bubbles and rough surface appearance, thus reducing print quality. It is recommended that put the filament into a dry box (humidity below 15%) immediately after opening the aesupport™ S-PAHT vacuum foil bag for printing. Please put the unused filament back into the original aluminum foil bag for sealed storage.

After the material is damp, there will be more printing ozzing, bubbles extruded and rough printing surface. Please dry the filament in an oven at 80-100℃ for 4-6h to restore the printing quality of aesupport™ S-PAHT.

It is recommended to use hardened steel and above grade nozzles made by Phaetus, which can effectively improve the print quality. Besides, it is recommended that the thickness of the heating block is longer 12mm.

In dual-extruder printing mode, the material in the standby nozzle will deteriorate due to prolonged heating, and the deteriorated material needs to be squeezed out before the print nozzle is switched, so it is necessary to use the Wipe wall or Wipe tower function in the slicing software.

After the printing is completed, the printed part can be annealed and then the aesupport™ S-PAHT removal step can be performed. During the annealing process, aesupport™ S-PAHT can play the role of supporting the body material, reducing the dimensional deformation of the body material and improving the mechanical properties of the body material. Annealing conditions: set according to the requirements of the body material.

 

Extrusion Force vs Print Speed Test

Test parameters: 12mm length brass heat block, BMG extruder, Phaetus Hardened Steel Nozzle, Nozzle size 0.4mm, Layer Height 0.2mm.

Packing List